A demo of the real time reporting software will be shown. This system utilizes a cellular network versus the standard IT network and cloud based software that can be accessed from anywhere without the need to open IT ports or use static IP addresses.

Tuesday November 30 - 3 sessions (10:30 am ET, 1 pm ET and 3:30 pm ET)ĪirAccess - This session will cover the NEW revolutionary subscription Air Access system. I typically set it to monitor the 'disarm' zone.Alarm Lock has scheduled webinars for November 30 - December 2. Note that you have to configure the HSM to monitor at least one zone for it to operate. It is one-way communication to the HSM to show status.

The system cannot be controlled from the HSM.

This will hopefully improve in the future.

Installation and app are clunky for now.

I have another dashboard with the desired switches I want to use (and I also have a tile for the Alarm System Interlogix Driver templated as HSM to show the status of the alarm). I have one dashboard showing the state of all the alarm zone devices.

Change 'name' if desired and click Save device.

Change preference to automatically turn off after 1s.

Configure notification options (select devices to send notifications to).

Go to Devices and check that all of your zones have been created.

Go to Devices | Select the 'Alarm System Interlogix Driver' device.

Click 'Create Bridge Device' (don't change the device network ID).

Go to Apps | Click on 'Alarm System Interlogix'.

Install the Drivers: Alarm Virtual Contact Sensor, Alarm Virtual Motion Sensor, Alarm Virtual Smoke Detector.

Install the Driver: Alarm Bridge Driver.

Set up the Interlogix Alarm System Bridge, as per instructions from LeeF Automation.

You can contact LeeF automation to obtain the bridge here: Procedure

Firmware version: NetworxAlarmSystemBridge-0.02.04-beta2-withBypass.bin.Networx Alarm System Bridge, with optional disarm kit.This is still a work in progress and there is room for improvement, but hopefully it can help to get you up and running. Here, I've restructured the code (and added new features) to run on Hubitat. The hub code was originally written for the SmartThings hub (by LeeF Automation). The bridge is a small WiFi-enabled device that allows your Interlogix NetworX alarm system to communicate with your hub. This code is used to operate the NetworX Alarm System Bridge (developed by LeeF Automation) on a Hubitat Elevate home automation hub. Networx Alarm System Bridge for Hubitat Overview

Add user networx alarm